
Short answer: Detention is what a carrier charges when its truck is held at your pickup or delivery beyond the free time, which is usually two hours. Layover is a daily charge when a driver has to wait overnight or longer because a load wasn't ready or couldn't be unloaded. Both are accessorial charges on top of the line haul, and both are mostly avoidable with accurate appointments, ready freight and quick dock turns.
Detention is one of the most common surprise lines on a truckload invoice, and it's a bigger deal for carriers than most shippers realize. Here's how detention and layover work, what they typically cost, why carriers care so much about them, and what you can do to keep them off your bills.
Detention, layover and TONU at a glance
| Charge | When it applies | How it's usually billed |
|---|---|---|
| Detention | The truck waits past the free time at pickup or delivery | Per hour after free time, often in 15-minute increments, sometimes with a daily cap |
| Layover | The driver is held overnight or longer through no fault of the carrier | A flat amount per day |
| TONU (truck ordered, not used) | A load is cancelled or isn't ready after the truck was dispatched | A flat fee per occurrence |
The exact terms live in the carrier's rules tariff, your contract or the rate confirmation for the load. Read them before the truck arrives, not after the invoice does.
How detention works
The clock usually starts when the driver checks in at the facility on time for the appointment. The first stretch is free time; once that runs out, detention starts. Two hours is the common standard, but it isn't a law. In a 2024 carrier survey by the American Transportation Research Institute (ATRI), most carriers that charge detention start at the two-hour mark, with a smaller share starting at one or three hours.
If the driver arrives late for the appointment, most carriers lose the right to bill detention, and many facilities will make a late driver wait for the next open door. Arriving early doesn't usually start the clock early either.
There's no standard rate. Published broker and shipper terms run from roughly $30 to $60 an hour, and carriers often quote more, especially for reefers and specialized equipment. That's why the rate confirmation matters: it should spell out the free time, the hourly rate, the billing increment and any maximum.
How layover and TONU work
Layover applies when a driver can't be loaded or unloaded the same day and has to wait until the next day, for example because the receiver ran out of door space or the freight wasn't ready. It's normally a flat daily charge and is separate from detention.
TONU covers a truck that was dispatched for a load that was cancelled or wasn't ready. Most terms require cancellation a set number of hours before pickup to avoid it.
Why carriers care so much
For a carrier, a truck sitting at a dock isn't earning money, and the driver's legal workday is ticking away. Federal hours-of-service rules limit property-carrying drivers to driving within a 14-hour window after coming on duty (49 CFR 395.3). Time spent waiting at your dock counts against that window, so a three-hour wait can cost the driver the rest of the day's driving and push back the next load.
The numbers are large. ATRI's 2024 detention study found that drivers were detained at 39.3% of stops in 2023, and at 56.2% of stops for refrigerated drivers. Detention cost the industry an estimated $3.6 billion in direct expenses and $11.5 billion in lost productivity that year, and while 94.5% of fleets charge detention, they're paid on fewer than half of those invoices (ATRI).
That's why detention shows up in pricing even when it doesn't show up on your invoice. Carriers remember slow facilities and quote them higher, or turn the loads down. In a tight market like late 2026, being a facility drivers don't mind visiting is worth real money. Our article on why truck freight rates are rising in 2026 covers the capacity side.
How to avoid detention and layover
Have the freight ready. Most detention at pickup comes down to freight that isn't staged, paperwork that isn't printed, or a load that's still being built when the truck arrives.
Set realistic appointments. Book appointment times your dock can actually meet, and don't stack several trucks into the same slot.
Load and unload in order. First come, first served by appointment, not by which driver calls loudest.
Use drop trailers where you can. If you ship or receive regularly, preloaded or drop trailers can take a lot of live-load time out of the equation.
Give accurate facility details. Hours, appointment rules, lumper requirements and any special equipment needed should be on the order so the carrier can plan.
Communicate early. If you know you'll be late, tell the carrier or broker before the truck arrives. It's often cheaper to reschedule than to pay for a truck sitting at your dock.
Track dwell time. Measure how long trucks spend at your docks. If you don't know your average turn time, you can't fix it.
How to handle a detention charge
Ask for the driver's check-in and check-out times and how they were recorded. Electronic tracking and gate records are the most reliable. Compare them with the appointment time and the free time in your rate confirmation. If the driver was late, or the delay was caused by the carrier, push back. If the delay was genuinely on your side, pay it and fix the cause.
On brokered loads, the broker usually collects the carrier's detention claim, checks it, and bills you. A good broker will also tell you when a facility keeps causing detention so you can deal with it. Our accessorial charges guide covers detention alongside the other fees, and freight charges explained shows where they land on the bill.
Frequently asked questions
What is detention in trucking?
Detention is a charge for keeping a truck at a pickup or delivery location beyond the agreed free time, usually two hours. It's billed per hour after free time ends.
How much is detention per hour?
There's no standard rate. Published broker and shipper terms run from roughly $30 to $60 an hour, and carriers often ask for more on refrigerated and specialized loads.
What is the difference between detention and layover?
Detention covers waiting time on the same day, billed by the hour. Layover covers a driver held overnight or longer, billed as a flat daily amount.
What is a TONU charge?
TONU stands for truck ordered, not used. It's a flat fee a carrier charges when a load is cancelled or not ready after the truck has been dispatched.
Who pays detention, the shipper or the receiver?
Whoever is responsible for the delay usually pays, but it depends on the contract. On many shipments the carrier bills the party that hired it, and that party recovers the cost from the shipper or receiver whose dock caused the wait.
How can shippers reduce detention charges?
Have freight ready before the truck arrives, set appointments the dock can meet, unload by appointment order, use drop trailers where possible, and warn the carrier early about delays.
Need a carrier that knows your docks and your appointment rules? Request a quote and tell us about your lanes.
Cover photo: ELEVATE on Pexels.



